TAPCO TH-15A

Descripción

Imágenes

Enviar a un amigo

Opiniones

Tapco TH-15A Thump 15" Powered Speaker Specifications:

Acoustic Performance
Frequency Range (-10 dB): 40 Hz 20 kHz
Frequency Response (-3 dB): 50 Hz 18.5 kHz
Horizontal Coverage Angle: 90°
Vertical Coverage Angle: 60°
Maximum SPL Long-Term: 113 dB SPL @ 1m
Maximum SPL Peak: 116 dB SPL @ 1m

Input/Output
Input Type: Female XLR Balance/Unbalanced
Input Impedance: 20 kOhms balanced bridging; 10 kOhms unbalanced
Loop-through: Male XLR Balanced/Unbalanced (parallel with input)
Level Control: Rotating knob, 0 dB at center
Sensitivity: +4 dBu for full output (Level Control @ center); -36 dBu for full output (Level Control @ max)

Transducers
Low Frequency: 15" (381mm) with steel frame, paper cone woofer
High Frequency: Horn loaded 1" (25mm) exit compression driver.

Power Amplifiers

Low Frequency Power Amplifier:
Rated Power: 150 Watts, 8-ohm load, 182 watts peak
THD: <0.1%
Signal-to-Noise Ratio: >-94 dB, 20 Hz to 20 kHz, unweighted, referenced to 138 watts into 8 ohms
Design: BTL Class D

High Frequency Power Amplifier
Rated Power: 50 watts, 4-ohm load, 60 watts peak
THD: <0.1%
Signal-to-Noise Ration: >-97 dB, 20 Hz to 20 kHz, unweighted, referenced to 50 watts into 4 ohms
Design: Class AB

Electronic Crossover
Crossover Type: 24 dB/octave
Crossover Frequency: 3 kHz

Equalization
Low Frequency EQ: ±15 dB @ 80 Hz, shelving
Mid Frequency EQ: ±15 dB, bandpass, sweepable from100 Hz to 8 kHz
High Frequency EQ: ±15 dB @ 12 kHz, shelving
Direct/EQ Switch: Bypasses EQ section

Protection Features
Over-excursion Protection: Second-order sub-sonic filter
Thermal Protection: Independent amplifier shutdown, auto reset
Driver Protection: Independent HF and LF compressors

AC Power Requirements
U.S.: 120 VAC, 60 Hz
Europe: 240 VAC, 50 Hz
Korea: 220 VAC, 60 Hz
Japan: 100 VAC, 50/60 Hz
AC Connector: 3-pin IEC 250 VAC, 20 A male
Fuse: 115 VAC: T 3.15 AL/250 V; 230 VAC: T 2 AL/250 V
Power Consumption: 320 watts with music, loud mix; 20 watts quiescent (idle)

Construction Features
Basic Design: Asymmetrical Trapezoidal
Material: Polypropylene
Finish: Textured
Handles: One on each side, one on top
Grille: Perforated metal with weather-resistant coating
Display LEDS: Front: Power ON; Rear: Power ON, OL (overload)

Dimensions: 27.1"H x 16.8"W x 11.7"D (689x427x296mm)
Weight: 36 lbs. (16.3 kg)
Mounting Methods: Pole-mountable via the built-in socket on the bottom of the cabinet. Be sure the pole is capable of supporting the weight of the TH-15A