CROWN XTi1000

Descripción

Imágenes

Enviar a un amigo

Opiniones

Productos Relacionados

Minimum Guaranteed Power, 1 kHz	XTi 1000
Per channel, both channels driven
Stereo, 2 ohms (per ch.) Stereo, 4 ohms (per ch.) Stereo, 8 ohms (per ch.) Bridge-Mono, 4 ohms Bridge-Mono, 8 ohms	700W* 500W 275W 1400W* 1000W
With 0.5% THD. *With 1% THD

The XTi Series of Crown amplifiers are professional tools designed and built for portable PA applications. The series includes three models which are identical except for output power: XTi 1000, 2000 and 4000. All are rugged and lightweight, and offer unmatched value in their class.

Integrated proprietary DSP with LCD front panel display
Accurate, uncolored sound with very low distortion for the best in music and voice reproduction
Advanced protection circuitry guards against: shorted outputs, open circuits, DC, mismatched loads, general overheating, high-frequency overloads and internal faults
Extremely versatile, handling a wide range of speaker impedances and outputs
Switch-mode universal power supply
Speaker presets for crossover frequencies, EQ, limiting, and delay
All products fill 2U rack spaces and weigh under 17 pounds; weight sets a new standard in lightweight amps (20% less)
Speakon® and binding post outputs, XLR inputs and loop-thrus
Comprehensive LED status per channel

Specifications

Sensitivity (volts RMS) for full rated power at 4 ohms	1.4V
Frequency Response (at 1 watt into 4 ohms, 20Hz - 20 kHz)	+0/–1 dB
Signal to Noise Ratio (below rated 1 kHz power at 8 ohms), A-weighted	100 dB
Damping Factor (8 ohm): 20 Hz to 400 Hz	> 500
Input Stage	Input is electronically balanced and employs precision 1% resistors.
AC Line Current	XTi 1000: 6.5A, At idle: Draws no more than 90 watts.
Crosstalk (below rated power) 20 Hz to 1 kHz	> 70 dB
Input Impedance (nominal)	20 kilohms balanced, 10 kilohms unbalanced
Load impedance (note: safe with all types of loads) Stereo Bridge mono	2-8 ohms (4-8 ohms in XTi 1000 A1 100V versions) 4-16 ohms (8-16 ohms in XTi 1000 A1 100V versions)
Voltage Gain (at 1 kHz, 8 ohm rated output)	XTi 1000: 30.5 dB.
Maximum Input Signal	+22 dBu typical
Operating Temperature	0° C to 40° C at 95% relative humidity (non-condensing)
AC Line Voltage and Frequency Configurations Available (± 10%)	100V, 120V, 220-240V 50/60 Hz
Ventilation	Flow-through ventilation from front to back
Cooling	Heat sinks and proportional-speed fan
Dimensions: Width, Height, Depth (behind mounting surface)	EIA Standard 19 in. W (EIA RS-310-B) x 3.5 in. (8.9 cm) H x12.25 in. (31.1cm) D
Net Weight, Shipping Weight	18.5 lb (8.4 kg), 21.5 lb (9.8 kg)